A wet chemical oxidation (WCO) method has been widely used to obtain the dissolved organic carbon (DOC) content and carbon isotope (δ13CDOC) ratios. However, it is sometimes difficult to get high precision results because not enough CO2 was oxidized from the natural water samples with low DOC concentrations. This improvement primarily aims to increase the water sample volume, improve the removal rate of dissolved inorganic carbon (DIC), and minimize the blank DOC from the standard solution. Following the improved procedure, the δ13C ratios of standardized DOC solutions were consistent with their actual values, and their differences were less than 0.2‰. The improved method demonstrated good accuracy and stability when applied to natural water samples with DOC concentrations ≥0.5 mg L-1, with the precisions of DOC concentrations and δ13C ratios were better than 0.07 mg L-1 and 0.1‰, respectively. More importantly, this method saved much pre-treatment time and realized batch processing of water samples to obtain their DOC contents and isotope ratios.
Keywords: aquatic environment; carbon isotope ratios; dissolved inorganic carbon removal; dissolved organic carbon; wet oxidation method.
© 2024 The Authors This is an Open Access article distributed under the terms of the Creative Commons Attribution Licence (CC BY 4.0), which permits copying, adaptation and redistribution, provided the original work is properly cited (http://creativecommons.org/licenses/by/4.0/).