Movement Analysis with Inertial Measurement Unit Sensor After Surgical Treatment for Distal Radius Fractures

Benedetta Zucchi; Massimiliano Mangone; Francesco Agostini; Marco Paoloni; Luisa Petriello; Andrea Bernetti; Valter Santilli; Ciro Villani

doi:10.1089/biores.2019.0035

Movement Analysis with Inertial Measurement Unit Sensor After Surgical Treatment for Distal Radius Fractures

Biores Open Access. 2020 May 21;9(1):151-161. doi: 10.1089/biores.2019.0035. eCollection 2020.

Authors

Benedetta Zucchi¹, Massimiliano Mangone¹, Francesco Agostini¹, Marco Paoloni¹, Luisa Petriello¹, Andrea Bernetti¹, Valter Santilli¹, Ciro Villani¹

Affiliation

¹ Department of Anatomy, Histology, Forensic Medicine and Orthopedics, Sapienza University, Rome, Italy.

Abstract

Inertial measurement unit (IMU) has recently been used to evaluate a movement of a body segment to provide accurate information of movement's characteristics. IMU systems have been validated to successfully measure joint angle during upper limb range of motion (ROM). The study aimed to retrospectively evaluate, using an IMU, the ROM recovery of the wrist after surgical treatment for distal-radius fractures with Kirschner wire fixation (KWF) or with volar plate fixation (VPF) and screws. To assess pain in the wrist joint, muscle-fatigue (MF), and functional difficulties in activities of daily living, we evaluated the patients through patient-related wrist evaluation questionnaire (PRWE) scale, disability of the arm, shoulder and hand (DASH) scale, Hand Grip Strength (HGS), and surface electromyography (EMG). We used a single IMU composed of three-axis gyroscope, a three-axis accelerometer, and a magnetometer. We calculated the value of ROM as a percentage with respect to the unaffected wrist. We also recorded surface-EMG signals over biceps brachialis, flexor carpi radialis (FCR), extensor carpi radialis (ECR), and pronator teres muscles. Forty patients were recruited for our study. Ulnar deviation (UD) was significantly higher for VPF than for KWF (p = 0.017); supination was significantly higher for VPF than for KWF (p = 0.031). The percentage of decay of the median frequency of FCR of volar plate was significantly higher than KWF. The HGS of KWF was significantly higher than VPF. In literature, there were no significant differences between the two types of treatment at long-term follow-up. Our results demonstrate a superior efficacy of VPF in terms of ROM improvement in UD and supination, but for these patients, muscle fatigue is greater than the KWF group. Based on the data available, VPF is similar to KWF for the treatment of distal radius fractures. The IMU sensor could be used in the future to evaluate ROM after surgery during patient's rehabilitation and to compare the effects with stratified analysis regarding age and fracture type, paralleled with cost-effectiveness analysis.

Keywords: distal radius fractures; percutaneous Kirschner wires; surface EMG; volar plate and screws; wearable medical device.