Introduction: Classical neutral mechanical alignment in total knee arthroplasty (TKA) has been a standard paradigm, while more recently, other alignment schemas, such as kinematic, individualized, and functional, have been explored. This study aimed to investigate the effect of three-dimensional (3D) computed tomography (CT)-based surgical robotics inputs on a classically trained surgeon's TKA component positions and alignment targets over time.
Materials and methods: Data from 1,394 consecutive robotically-assisted TKAs by a single surgeon from 2016 to 2020 were analyzed. Metrics collected included pre-balance planned implant component positions, final planned implant component positions after soft tissue balancing, and constitutional alignment from CT scans. Joint line obliquity was plotted against the arithmetic hip-knee angle (aHKA) using coronal plane alignment of the knee (CPAK). Three categories of alignment strategy were defined: true mechanical alignment (tMA), adjusted mechanical alignment (aMA), and no mechanical alignment (noMA).
Results: A shift to overall varus component positioning was observed over the years. Joint line obliquity according to CPAK showed a wider spread in later years, and the distribution of tibial and femoral coronal alignment angles expanded over time.
Conclusion: The study revealed a change in alignment targets and final positioning of components away from neutral biomechanical axes in a large volume of TKAs by a single, classically trained surgeon over five years of using a robotic arm-assisted TKA system with CT-based planning. The most dominant factor for this change was the use of 3D CT planning, allowing the surgeon to assess patient-specific anatomy and plan accordingly. Outcome data is needed to determine if this change in behavior and surgical technique was beneficial. In summary, using a CT scan-based robotically assisted technique led to a gradual and complete shift from tMA to predominantly a non-mechanically aligned philosophy in TKA.