A flat perfusion chamber was developed to study the interaction of blood platelets in flowing blood with cultured human vessel wall cells, their connective tissue matrix, and isolated connective tissue components at defined shear rate conditions. A cover slip covered with endothelial cells or extracellular matrix components was introduced into the chamber. Laser-Doppler velocimetry showed a symmetrical flow profile at flow rates between 50 and 150 ml/min (wall shear rate 300 to 1100 sec-1). Platelet deposition was estimated by using blood platelets labeled with indium-111 or by a morphometric method. Blood platelets did not adhere to endothelial cells at wall shear rates of 765 sec-1 and the endothelial cells remained attached for at least 10 min of perfusion. In preconfluent cultures of endothelial cells, blood platelets adhered to extracellular material in areas between the cells. Removal of endothelial cells by treatment with 0.5% Triton X-100 induced increased platelet adherence with a preference for certain, as yet unidentified, fibrillar structures of the extracellular matrix. Platelet adherence to equine collagen was also studied after coating the cover slips by spraying of small collagen droplets followed by air drying. Platelet adherence and the subsequent platelet aggregate formation occurred predominantly along visible collagen fibers. These studies showed that this perfusion chamber has a laminar and symmetrical flow allowing qualitative and quantitative investigation of platelet interaction with endothelial cells, their extracellular matrix, and pure connective tissue components. A variety of wall shear rates and exposure times can be applied at controlled conditions without removing cells or extracellular material.